How to connect Analog Fuel Sensor to FMB125 device. #

Step 1 - Preparation #

Ensure wiring Fuel Sensor to AIN1 signal of FMB125.
Ensure Power and SIM is normal.
Set IP, Port for the device sending to GoTrack Platform

Step 2 - Setup Analog Input #

Check Analog 1 value is available on the Platform by creating a sensor.
If the value is not available, send GPRS command to enable Analog Input Parameter:

setparam 50180:1

then, send reset command to the device:

cpureset

Step 3 - Setup Sensor #

Check again Analog 1 value is available.
Setup Tank information and Calibration values.